The design of a Hybrid feeder means the contents of the feeder are better protected when compared to the Method. With a Hybrid the vast majority of your pellet payload will get to the bottom still attached to the feeder. For those not familiar with the Hybrid feeder, it’s more enclosed than a Method and features raised sides, whereas a Method Korda Bait-Up Method Feeder. Many of the features that made the original so good, including the weighted fin that ensures that it always lands the right way up and the hookbait will always fall away from the feeder, increasing your chances of a quick bite. It is a one-piece design, which makes it very strong and durable, and incorporates a bait Automatic feeding machines should first be used when shrimp are 15 to 25 days old or when farmers start using pellets of 1.8- to 2.0-mm diameter. Before that, feeding should be done with traditional methods. Some Thai farmers begin to use the automatic feeders when the first estimates of survival rate and shrimp size are done. 1. Choose the right feeder and bait for the conditions and species you're targeting. 2. Cast accurately with your feeder rod and consistently to build up a baited area that will attract fish. 3. Be patient and wait for the fish to find your bait. Don't be tempted to reel in the feeder too soon. 4. Catch more fish on the method feeder. Korum's Adam Firth reveals his tips on how to tie an effective method feeder rig. Thread a long stringer needle right through your feeder and grab the elastic with the hook. Just pull the elastic through until the ring reaches the tube of the feeder. Thread the loose end down from the top and through the plastic loop at the top of the feeder. Clamp it to one side of the plastic loop using another half-turn tuck. Share. Posted September 1, 2010. IMO depth of water should make no difference to your method mix or how hard it is on a method feeder. For me the best method feeder mix will still be on my feeder 2 hours after being cast in to any depth of water (just dissolved a bit smaller). To put it simply, method feeders aren't for feeding a swim or to put TOP 10 METHOD FEEDER TIPS. 1. A flat Method feeder is best when feeder fishing close to islands. These usually have a small shelf or slope that the fish patrol. An oval Method ball could easily roll down the slope or off the shelf away from the fish, but a flat Method feeder will stay in the targeted area where they are on the hunt for food. 2 Joe Carass shows you how a couple of simple ingredients can make the easiest, foolproof Method feeder mix that catches loads of fish! DR3x.

how to use a method feeder